SPA-2X1GE-V2 Cisco SPA Card 2-Port Gigabit Ethernet SPA Adapters Interface Card

SPA-2X1GE-V2 Specification

• Cisco Catalyst 6500 Series Switches (2 and 10-port GE SPAs)
• Cisco 7600 Series Router (2-, 5-, and 10-port GE SPAs)
• Cisco 12000 Series Router (2-, 5-, 8-, and 10-port GE SPAs)
• Cisco XR 12000 Series Router (2-, 5-, 8-, and 10-port GE SPAs)
• Cisco ASR 1000 Series Router (2-, 5-, 8-, and 10-port GE SPAs)
• Cisco CRS Carrier Routing System (5-, 8-, and 10-port GE SPAs)
• Cisco 10000 Series Router (2 and 5-port GE SPAs)

2*, 5, 8, or 10 Gigabit Ethernet ports
* Usable in combination of SFP and RJ-45 ports for a total of 2 Gigabit Ethernet ports

• Short wavelength (SX)
• Long reach/long haul (LX/LH)
• Extended distance (ZX) SFP
• SFP-GE-T (5-, 8-, and 10-port Gigabit Ethernet SPAs)
• Built-in RJ-45 (2-port Gigabit Ethernet SPA)

SPA status: Bicolor green and amber LEDs encode the SPA status as follows:
• LED off: SPA is powered off
• LED amber: SPA is powered on and initializing
• LED green: SPA is powered on and operational
In addition to the status LED, the SPAs also have a bicolor, surface-mount, right-angle LED dedicated to each port to indicate port status. The green and amber LEDs encode the port status as follows:
• LED off: Port is not enabled by software
• LED: Port is enabled by software, but there is a problem with the Ethernet link
• LED green: Port is enabled by software, and there is a valid Ethernet link

• Autonegotiation
• Full-duplex operation
• 802.1Q VLAN termination
• 802.1ad QinQ termination (stacked VLAN processing)
• Jumbo Frames support (9188 bytes)
• Support for command-line interface (CLI)-controlled online insertion and removal (OIR)
• 802.3x flow control
• Bridge protocol data unit (BPDU), Cisco Discovery Protocol, and VLAN Trunking Protocol (VTP) filtering
• Layer 2 Protocol (BPDU, Cisco Discovery Protocol, and VTP) Tunneling
• Layer 2 access list (MAC address-based filtering)
• Up to 8000 VLANs per SPA and subject to a limit of 4000 VLANs per port for 802.1q
• Up to 5000 MAC accounting entries per SPA (source MAC accounting on the ingress, and destination MAC accounting on the egress)
• Up to 2000 MAC address entries for destination MAC address filtering per SPA, and up to 1000 MAC address filtering entries per port
• Per-port byte and packet counters for policy drops; oversubscription drops; cyclic redundancy check (CRC) error drops; packet sizes; and unicast, multicast, and broadcast packets
• Per-VLAN byte and packet counters for policy drops; oversubscription drops; and unicast, multicast, and broadcast packets
• Per-port byte counters for good bytes and dropped bytes

Network management using:
• Host-system CLI
• Simple Network Management Protocol (SNMP)
Inventory- and asset management-related MIBs:
• Entity-MIB (RFC 2737)
• Cisco-entity-asset-MIB
Fault management:
• Cisco-entity-field-replaceable unit (FRU)-control-MIB
• Cisco-entity-alarm-MIB
• Cisco-entity-sensor-MIB
Physical interface management:
• IF-MIB
• Etherlike-MIB (RFC 2665)
Other MIBs:
• Remote Monitoring (RMON)-MIB (RFC 1757)
• Cisco-class-based-QoS-MIB
• MPLS-related MIBs
• Ethernet MIB/RMON

• OIR of the SPA within the SIP and the optics within the SPA
• Field-replaceable SFP optical modules

Weight: 0.75 lb (0.34 kg)
Height: 0.8 in. (2.03 cm) (single height)
Width: 6.75 in. (17.15 cm)
Depth: 7.28 in. (18.49 cm)

• Storage temperature: -38 to 150°F (-40 to 70°C)
• Operating temperature, nominal: 32 to 104°F (0 to 40°C)
• Operating temperature, short term: 32 to 131°F (0 to 55°C)
• Storage relative humidity: 5 to 95% relative humidity
• Operating humidity, nominal: 5 to 85% relative humidity
• Operating humidity, short term: 5 to 90% relative humidity
• Operating altitude: -60 to 4000m

Safety
• UL 60950-1
• CSA C22 No. 60950-1
• EN 60950-1
• IEC 60950-1
• AS/NZS 60950
• EN 60825-1
• EN 60825-2
• 21 CRF 1040
EMC
• CFR 47
• FCC Part 15-Class A
• ICES 003-Class A
• CISPR 22 Class A
• EN 55022 Class A
• EN 300386 Class A
• AS/NZS Class A
• VCCI-Class B
• EN 50082-1
• EN 55024
• IEC/EN61000-4-2 Electrostatic Discharge Immunity (8-kV contact, 15-kV air)
• IEC/EN61000-4-3 Radiated Immunity (10 V/m)
• IEC/EN61000-4-4 Electrical Fast Transient Immunity (2-kV power, 1-kV signal)
• IEC/EN61000-4-5 Surge AC Port (4-kV CM, 2-kV DM)
• IEC/EN61000-4-5 Surge Signal Port (1-kV indoor, 2-kV outdoor)
• IEC/EN61000-4-5 Surge DC Port (1 kV)
• IEC/EN61000-4-6 Immunity to Conducted Disturbances (10 Vrms)
• IEC/EN61000-4-8 Power Frequency Magnetic Field Immunity (30 A/m)
• IEC/EN61000-4-11 Voltage Dips, Short Interruptions, and Voltage Variations
Telecom
• IEEE 802.3z
Industry Standards
The Cisco Gigabit Ethernet SPAs are designed to meet the following requirements (some qualifications are currently in progress):
• SR-3580 Network Equipment Building Standards (NEBS): criteria levels (Level 3 compliant)
• GR-63-CORE-NEBS: Physical protection
• GR-1089-CORE-NEBS EMC and safety