FAP-221E Specification
|
| Hardware |
| Hardware Type |
Indoor AP |
| Number of Radios |
2 + 1 BT/BLE |
| Number of Antennas |
4 Internal + 1 Internal BT/BLE |
| Antenna Type and Peak Gain |
PIFA: 4 dBi for 2.4 GHz, 5 dBi for 5 GHz |
| Frequency Bands (GHz)* |
2.400–2.4835, 5.150–5.250, 5.250–5.350, 5.470–5.725,5.725–5.850 |
| Radio 1 Capabilities |
2.4 GHz b/g/n (2x2:2 stream)
20/40 MHz (256 QAM)
|
| Radio 2 Capabilities |
5 GHz a/n/ac (2x2:2 stream)
20/40/80 MHz (256 QAM)
|
| Maximum Data Rate |
Radio 1: up to 400 Mbps
Radio 2: up to 867 Mbps
|
| Bluetooth Low Energy (BT/BLE) Radio |
Bluetooth scanning and iBeacon advertisement @ 4 dBm max TX power |
| Interfaces |
1x 10/100/1000 Base-T RJ45 |
| Power over Ethernet (PoE) |
IEEE 802.3af |
| Simultaneous SSIDs |
16 (14 if background scanning enabled) |
| EAP Type(s) |
EAP-TLS, EAP-TTLS/MSCHAPv2, EAPv0/EAP-MSCHAPv2, PEAPv1/EAP-GTC, EAP-SIM, EAP-AKA, EAP-FAST |
| User/Device Authentication |
WPA™ and WPA2™ with 802.1x or Preshared key, WEP,Web Captive Portal, MAC blacklist & whitelist |
| Maximum Tx Power |
2.4 GHz: 23 dBm / 200 mW (2 chains combined)*
5 GHz: 24 dBm / 251 mW (2 chains combined)*
|
| Kensington Lock |
Yes |
| IEEE Standards |
802.11a, 802.11b, 802.11d, 802.11e, 802.11g, 802.11h, 802.11i,802.11j, 802.11k, 802.11n, 802.11r, 802.11v, 802.11ac, 802.1X,802.3af, 802.3az |
| SSID Types Supported |
Local-Bridge, Tunnel, Mesh |
| Per Radio Client Capacity |
Up to 512 |
| Cellular Co-existence |
Yes |
| LED Off Mode |
Yes |
| Advanced 802.11 Features |
| 802.11ac MU-MIMO Wave 2 |
Yes |
| Transmit Beam Forming (TxBF) |
Yes |
| Low-Density Parity Check (LDPC) Encoding |
Yes |
| Maximum Likelihood Demodulation (MLD) |
Yes |
| Maximum Ratio Combining (MRC) |
Yes |
| A-MPDU and A-MSDU Packet Aggregation |
Yes |
| MIMO Power Save |
Yes |
| Short Guard Interval |
Yes |
| Wireless Monitoring Capabilities |
| Rogue Scan Radio Modes |
Background, Full-time |
| WIPS / WIDS Radio Modes |
Background, Full-time |
| Packet Sniffer Mode |
Yes |
| Spectrum Analyzer |
Yes |
| Dimensions |
| Length x Width x Height |
6.3 x 6.3 x 1.85 inches(160 x 160 x 47 mm) |
| Mounting Options |
Ceiling, T-Rail, and Wall |
| Included Accessories |
Mount kits for Ceiling, T-Rail, and Wall |
| Environment |
| Power Supply |
SP-FAP200-PA-XX, GPI-115,or GPI-130 |
| Power Consumption (Max.) |
12.36 W |
| Humidity |
5–90% non-condensing |
| Operating / Storage Temperature |
-4–113°F (-20–45°C) /-40–158°F (-40–70°C) |
| Directives |
Low Voltage Directive • RoHS |
| UL2043 Plenum Material |
Yes |
| Mean Time Between Failures |
>30 Years |
| IP Rating |
|
| Surge Protection Built In |
|
| Hit-less PoE Failover |
No |
| Certifications |
| Wi-Fi Alliance Certified |
Yes |
| DFS |
FCC, IC, CE, Japan, Taiwan |
| Warranty |
| Limited Lifetime Warranty |
Yes |
| * Frequency selection and power may be restricted to abide by regional regulatory compliance laws. |
Your message must be between 20-3,000 characters!
English
