| Model Number: | S5735-S48P4X | Switch Capacity: | 176 Gbps/432 Gbps |
|---|---|---|---|
| Product Name: | S5735-S48P4X 48*10/100/1000BASE-T Ports, 4*10GE SFP+ Ports, PoE+ Switch | Transmission Rate: | 10/100/1000Mbps |
| Communication Mode: | Full-Duplex & Half-Duplex | Condition: | Original New |
| Ports: | ≥ 48 | Function: | LACP, QoS, VLAN Support |
| High Light: | Huawei Network Switches S5735-S48P4X,Half Duplex Huawei Network Switches,100Mbps Huawei Network Switches |
||
Huawei S5735-S48P4X 48*10/100/1000base-t Ports4*10ge Sfp+ Ports Poe+ Switch
S5735-S48P4X appearance
| 1 | Forty-eight PoE+ 10/100/1000BASE-T ports | 2 |
Four 10GE SFP+ ports Applicable modules and cables:
|
| 3 | One console port | 4 | One ETH management port |
| 5 | One USB port | 6 |
One PNP button NOTICE:
To restore the factory settings and reset the switch, hold down the button for at least 6 seconds. To reset the switch, press the button. Resetting the switch will cause service interruption. Exercise caution when you press the PNP button. |
| 7 |
Ground screw NOTE:
It is used with a ground cable.
|
8 |
Power module slot 1 NOTE:
Applicable power module:
|
| 9 |
Power module slot 2 NOTE:
Applicable power module:
|
- | - |
|
Item |
Description |
|---|---|
| Memory (RAM) | 1 GB |
| Flash | 512 MB in total. To view the available flash memory size, run the display version command. |
| Mean time between failures (MTBF) | 54.88 years |
| Mean time to repair (MTTR) | 2 hours |
| Availability | > 0.99999 |
| Service port surge protection | Common mode: ±7 kV |
| Power supply surge protection |
|
| Dimensions (H x W x D) |
|
| Weight (with packaging) | 7.64 kg (16.84 lb) |
| Stack ports | Any 10/100/1000BASE-T ports or 10GE SFP+ ports (applicable in V200R019C10 and later versions) |
| RTC | Supported |
| RPS | Not supported |
| PoE | Supported |
| Rated voltage range |
|
| Maximum voltage range |
|
| Maximum power consumption (100% throughput, full speed of fans) |
|
|
Typical power consumption (30% of traffic load)
|
59 W |
| Operating temperature |
-5°C to +50°C (23°F to 122°F) at an altitude of 0-1800 m (0-5906 ft.)
NOTE:
When the altitude is 1800-5000 m (5906-16404 ft.), the highest operating temperature reduces by 1°C (1.8°F) every time the altitude increases by 220 m (722 ft.). The switch cannot be started when the ambient temperature is lower than 0°C (32°F). |
| Short-term operating temperature |
-5°C to +55°C (23°F to 131°F) at an altitude of 0-1800 m (0-5906 ft.) NOTE:
When the altitude is 1800-5000 m (5906-16404 ft.), the highest operating temperature reduces by 1°C (1.8°F) every time the altitude increases by 220 m (722 ft.). The equipment can operate beyond the normal operating temperature range for a short-term period, but the following conditions must be met:
The equipment cannot start when the temperature is lower than 0°C (32°F). The maximum distance of optical modules used in these conditions cannot exceed 10 km. |
| Storage temperature | -40°C to +70°C (-40°F to +158°F) |
| Noise under normal temperature (27°C, sound power) | < 58.9 dB(A) |
| Relative humidity | 5% to 95%, noncondensing |
| Operating altitude | 0-5000 m (0-16404 ft.) |
| Certification |
|
| Part number | 98010943 |
Contact Person: Mrs. Laura
Tel: +86 15921748445
Fax: 86-21-37890191
