Product Details:
|
Part Number: | S5730-36C-HI | Brand: | HUAWEI |
---|---|---|---|
Fixed Ports: | 24 X 10/100/1,000 Base-T , 4 X 10 GE SFP+ | Maximum Power: | 74W |
Switching Capacity: | 758 Gbit/s | Condition: | New With 1Year Warranty |
High Light: | gigabit network switch,huawei ethernet switches |
Huawei S5730-HI gigabit Ethernet switches (hereinafter referred to as the S5730-HI) are Huawei-developed next-generation agile switches that provide fixed full gigabit access and 10 GE uplink interfaces as well as one or two slots for uplink interface extension.
Item | S5730-36C-HI |
---|---|
Fixed Ports | 24 x 10/100/1,000 Base-T ports, 4 x 10 GE SFP+ ports |
Dimensions (W x D x H) | 442 mm x 420 mm x 44.4 mm |
Extended Slots | One extended slot, supporting 8-port 10 GE electrical, 8-port 10 GE optical, or 2-port 40 GE optical interface card |
Input Voltage | AC: Rated AC voltage: 100V to 240V; 50/60 Hz Max. AC voltage: 90V to 264V; 47 Hz to 63 Hz |
DC: Rated DC voltage: -48V to -60V Max. DC voltage: -38.4V to -72V |
|
Maximum Power Consumption (without cards) |
74W |
Operating Temperature | 0m to 1,800m altitude: 0°C to 45°C 1,800m to 5,000m altitude: The operating temperature reduces by 1ºC for each 220m increase in altitude. |
Relative Humidity | 5% to 95% (non-condensing) |
Heat Dissipation | Air cooling heat dissipation, intelligent speed adjustment, and pluggable fans |
1 | Twenty-four 10/100/1000BASE-T ports | 2 | Four 10GE SFP+ ports
Applicable modules and cables:
|
3 | One ETH management port | 4 | PNP button
NOTICE:
To restore the factory settings and reset the switch, hold down the button for at least 6 seconds. To reset the switch, press the button. Resetting the switch will cause service interruption. Exercise caution when you press the PNP button. |
5 | One console port | 6 | One USB port |
7 | Ground screw
NOTE:
It is used with a ground cable.
|
8 | ESN label
NOTE:
You can draw it out to view the ESN and MAC address of the switch. |
9 | SSD card slot
NOTE:
Pluggable SSD card supported: SSD-240GB |
10 | Rear card slot
NOTE:
Cards supported:
|
11 | Fan slot
NOTE:
Applicable fan module: FAN-028A-B |
12 | Power module slot 2
NOTE:
Applicable power modules:
|
13 | Power module slot 1
NOTE:
Applicable power modules:
|
- | - |
Service features
Item | Description |
---|---|
MAC Address Table | IEEE 802.1d standards compliance |
256K MAC address entries | |
MAC address learning and aging | |
Static, dynamic, and blackhole MAC address entries | |
Packet filtering based on source MAC addresses | |
VLAN | 4094 VLANs |
Guest VLAN and voice VLAN | |
GVRP | |
MUX VLAN | |
VLAN assignment based on MAC addresses, protocols, IP subnets, policies, and ports | |
VLAN mapping | |
Wireless Service | AP access control, AP domain management, and AP configuration template management |
Radio band management, unified static configuration, and dynamic centralized management | |
WLAN basic services, QoS, security, and user management | |
CAPWAP, tag/terminal location, and spectrum analysis | |
Ethernet Loop Protection | RRPP ring topology and RRPP multi-instance |
Smart Link tree topology and Smart Link multi-instance, providing millisecond-level protection switchover | |
SEP | |
ERPS (G.8032) | |
BFD for OSPF, BFD for IS-IS, BFD for VRRP, and BFD for PIM | |
STP (IEEE 802.1d), RSTP (IEEE 802.1w), and MSTP (IEEE 802.1s) | |
BPDU protection, root protection, and loop protection | |
MPLS | MPLS L3VPN |
MPLS L2VPN (VPWS/VPLS) | |
MPLS-TE | |
MPLS QoS | |
IP Routing | Static routes, RIP v1/2, RIPng, OSPF, OSPFv3, IS-IS, IS-ISv6, BGP, BGP4+, ECMP, and routing policy |
Interoperability | VLAN-Based Spanning Tree (VBST), working with PVST, PVST+, and RPVST |
Link-type Negotiation Protocol (LNP), similar to DTP | |
VLAN Central Management Protocol (VCMP), similar to VTP | |
IPv6 Features | Neighbor Discover (ND) |
PMTU | |
IPv6 Ping, IPv6 Tracert, and IPv6 Telnet | |
ACLs based on source IPv6 addresses, destination IPv6 addresses, Layer 4 ports, or protocol types | |
Multicast Listener Discovery snooping (MLDv1/v2) | |
IPv6 addresses configured for sub-interfaces, VRRP6, DHCPv6, and L3VPN | |
Multicast | IGMP v1/v2/v3 snooping and IGMP fast leave |
Multicast forwarding in a VLAN and multicast replication between VLANs | |
Multicast load balancing among member ports of a trunk | |
Controllable multicast | |
Port-based multicast traffic statistics | |
IGMP v1/v2/v3, PIM-SM, PIM-DM, and PIM-SSM | |
MSDP | |
MVPN | |
QoS/ACL | Rate limitation in the inbound and outbound directions of a port |
Packet redirection | |
Port-based traffic policing and two-rate three-color CAR | |
Eight queues on each port | |
DRR, SP, and DRR + SP queue scheduling algorithms | |
WRED | |
Re-marking of the 802.1p and DSCP fields of packets | |
Packet filtering at Layer 2 to Layer 4, filtering out invalid frames based on the source MAC address, destination MAC address, source IP address, destination IP address, TCP/UDP port number, protocol type, and VLAN ID | |
Queue-based rate limitation and shaping on ports | |
Security | Hierarchical user management and password protection |
DoS attack defense, ARP attack defense, and ICMP attack defense | |
Binding of the IP address, MAC address, port number, and VLAN ID | |
Port isolation, port security, and sticky MAC | |
MAC Forced Forwarding (MFF) | |
Blackhole MAC address entries | |
Limit on the number of learned MAC addresses | |
IEEE 802.1x authentication and limit on the number of users on a port | |
AAA authentication, RADIUS authentication, and HWTACACS authentication | |
NAC | |
SSH V2.0 | |
HTTPS | |
CPU protection | |
Blacklist and whitelist | |
Attack source tracing and punishment for IPv6 packets such as ND, DHCPv6, and MLD packets | |
Secure Boot | |
IPSec | |
ECA | |
Deception | |
Reliability | LACP |
E-trunk | |
Ethernet OAM (IEEE 802.3ah and IEEE 802.1ag) | |
ITU-Y.1731 | |
DLDP | |
LLDP | |
BFD for BGP, BFD for IS-IS, BFD for OSPF, and BFD for static route | |
VXLAN | VXLAN L2 and L3 gateways |
Centralized and distributed gateway | |
BGP-EVPN | |
Configured through the NETCONF protocol | |
Super Virtual Fabric (SVF) | The S5730-HI can work as the parent node to vertically virtualize downlink switches and APs as one device for management |
A two-layer client architecture is supported | |
IGMP snooping can be enabled on Access Switches (ASs) and the maximum number of access users on a port can be configured | |
ASs can be independently configured. Services that are not supported by templates can be configured on the parent | |
Third-party devices are allowed between SVF parent and clients | |
iPCA | Directly coloring service packets to collect real-time statistics on the number of lost packets and packet loss ratio |
Collection of statistics on the number of lost packets and packet loss ratio at network and device levels | |
TWAMP | Two-way IP link performance measurement |
Measurement on two-way packet delay, one-way packet loss rate, and one-way packet jitter | |
Management and Maintenance | iStack |
Virtual cable test | |
SNMP v1/v2c/v3 | |
RMON | |
Web-based NMS | |
System logs and alarms of different levels | |
GVRP | |
MUX VLAN | |
802.3az Energy Efficient Ethernet (EEE) | |
NetStream | |
Intelligent O&M |
Related products
AIR-AP18321I-H-K9 AIR-AP18521-E-K9 AIR-AP2802I-H-K9
AIR-AP-3802I-E-K9 AIR-CAP1602I-C-K9 AIR-CAP2701I-E-K9
AIR-CAP3602I-C-K9 AIR-CT2504-15-K9 AIR-CT5508-25-K9
AP5030DN AP7030DN AP8030DN
AP8130DN AP6010SN-GN AP2050DN-S
AP6510DN-ASG AP2010DN AP6010-DN
Contact Person: Laura
Tel: 15921748445
Fax: 86-21-37890191